High Endurance Muzzle Brake Suppressors 7.62mm Machine Guns
The device protrudes past the end of the barrel 7.5 inches and goes
back over the barrel to a point in front of the gas block. A barrel
fitting that attaches to the barrel near the gas block assembly is
used in conjunction with the threaded muzzle to align and secure
the device to the weapon. Once the barrel fitting is installed no
tools are required to remove or install the MBS to the weapon. The
28 oz weight of the device is offset due to the flash hider being
removed from the weapon.
Caliber 7.62mm / .30 caliber
Diameter 1.5 inches
Length past muzzle 7.25 inches
Overall length 12.2 inches
Weight 30 ounces
Construction Fusion welded 300 series stainless steel
Endurance Meets SOPMOD objective of 30,000 rounds under
various firing schedules.
Note: This suppressor was tested by Crane on an HK21, by firing
1400 rounds in 15 minutes with no degradation in performance.
Machine gun suppressor pricing is based on customer providing the
applicable weapon and 100 rounds of linked ammo per suppressor for
testing of each unit before shipment.